Posts: 23
Threads: 1
Joined: Jun 2010
i just received some UG npp in 10 ml vials and it is very cloudy. I've been using gear for a long time and I never seen cloudy gear before but this is my first time with npp and would like to know if it is normal for npp to be cloudy and not clear like all other gear ive used ???
Thanks in advance bros
Posts: 101
Threads: 2
Joined: Aug 2010
sounds crashed try warming it up. hot water, hair drier, microwave all work good. it should clear up and be gtg
Posts: 444
Threads: 41
Joined: Aug 2009
yeah bro it just sounds like it needs warming up , has it been kept inthe cold ? because the way UG stuff is made the powder/crystals dont always suspend in the oils once it gets cold , sitthe vial under a warm tab for 3 min and then shake it, if it goes clear your gear is gtg , if not its bunk !
Disclaimer: Hypermuscles.com does not promote the use of anabolic steroids without a doctor's prescription. The information we share is for entertainment and research purposes only.
Posts: 23
Threads: 1
Joined: Jun 2010
ok bros i nuked it for 10 sec and it did clear up but as soon as it cools downs it goes back to cloudy...now what does this mean? do you bros think its ok to pin or what.
thanks for your help
GF
Posts: 101
Threads: 2
Joined: Aug 2010
try a blow drier for 30 sec then shake the shit out of it see if that works.
when all the pointers mentioned above tried, but still failed.... get yourself a .45 or .22 watman syringe filter and re-filter the oil at room temp into a pre-sterilized SEALED vial, this should do the trick, it also might be moisture in the product
Rex
Posts: 1
Threads: 0
Joined: Jun 2011
Rex Wrote:it also might be moisture in the product
Rex
This.
Stick a pin in the top of the vial to vent gas/moisture out and put in the oven on low heat for an hr or so.
Could of crashed too. Gear came out of solution. Myself, I would just heat it up till gear dissolved back into oil and pin. Done it many times.
