DRAWING OIL



this is a good read allso, please mod if posted in wrong section please remove or let me know and ill do it


DRAWING OIL: First, Remove the cap from your needle; draw back about 1 cc of air.
Insert the needle into the rubber stopper on the vial; slowly push the air inside the vial.
This will increase the pressure inside of the vial making the process of drawing the oil
Easier. Now draw the desired amount. Remove the needle and cap it. Unscrew the old needle and put a new needle on the syringe. Drawing will always dull a Needle. Dull needles hurt, and needles are too cheap to be stingy with them. Change the needle!
Next, turn the syringe up (needle tip up) and slowly press the plunger Until you have a couple of drops of oil come out of the tip, you can tap the syringe to get Any small air bubbles out but it isn’t necessary. For opening amps, obviously an amp opener is easiest. However if you don’t have one or simply don’t want to bother with getting one it’s not that big of a deal. Using a metal file, score the neck of the amp all the way around the amp. Wrap the amp in a Klenex and snap off the top. Inspect the oil for any glass fragments, very rarely do any glass fragments ever get inside the amp. Set the amp down on a flat level surface. Uncap your syringe and put the needle all the way to the bottom of the amp inside one of the corners. Slowly and steadily, draw the oil from the amp by pulling back on the plunger, If your careful, you won’t have to change the needle. If you bump the needle into the glass bottom of the amp, you should probably change it. Believe it or not, this will seriously dull a needle. And Dull needles Hurt.


INJECTION TECHNIQUE: You may want to experiment with your injections on an orange before you move onto your body. Locate the outer middle/upper section of your glute. For a picture go to www.spotinjections.com there is even a video that will show you the entire process. The correct injection site is critical. Believe me, you don’t want to
Put a needle into your sciatic nerve. Using your free hand take three fingers and stretch the skin over your injection site. This will keep the needle from bouncing off your skin and will also reduce bleeding and oil leakage after you remove the needle. The hole made
By the injection will become covered by the skin you stretched out of the way.
When you start your injection insert the needle in straight, do not go at a funny angle or move your hand around while inserting. When you insert the needle you may want to go slow (Trust me, it really isn’t that painful). Push the needle all the way in, using two fingers pull the plunger back about a quarter of an inch; check for air bubbles (You should see a couple of small air bubbles come in the chamber of the syringe when pulling back on the plunger) [This is called “ASPIRATING” Never inject any where in your body without first ASPIRATING] If you pull back on the plunger and blood comes into the syringe, Immediately REMOVE the needle from your glute; Your about to inject into a vein and that would be very bad. In fact it’s dangerous. Usually the vein will just collapse but the oil could get to your heart, this would be very painful and potentially deadly.

Now back to Injecting.

You’ve put the needle in, you’ve aspirated, and you’ve got a couple of air bubbles. Now slowly and steadily inject the oil until the syringe is empty. Remove the needle; with an alcohol treated cotton ball apply slight pressure to the injected site and massage gently for about 30 seconds to help disperse the oil. That’s it. Be sure to properly dispose of your needles. It’s not fair to Otto the garbage man if he has to get stuck with one of your used needles because you were too lazy to dispose of it properly.