Bad test e ?
 

Can test e go bad if heated up to much. I been heating up water till it barely starts to boil and putting it into a clear small cup. I then get the glass vial and set in the the cup {not covering the top of course} for a few minutes then inject. Since then i have not had any to no pain at all. Just wondering if i am diluting or messing up the gear?

I had testoviron which is pharmaceutical testosterone enanthate and it says on the package that it should be stored in a shady place with room temperature of no more than 25 degrees celsius. I don't know the reason for that but that's what it says.

I normally stick mine in a hot cup of coffee for a few seconds, it does make the injection easier if its warm.

I dont think its bad if you put it for a few seconds in hot water however mine is always room temperature and I feel no pip when injecting it.
Did you really notice any difference in pip after warming it up?

no matter what i did i had pretty severe pip with test e

now on 5th week with test c and zero pain its room temp

was this common for each manufacturer you used?

Think some may react a little diff. than others. I have always used Test E. and never had a prob., shared a dose from same vial for my buddy and he had some bad pip and reddish itchy rash about 4 hours afterwards. He never had a problem with Test C. But for some reason the E give him trouble. He got throught it for awhile until he got his Cypionate back in by warming up the Test E. before inj.

i seem to always get a fair amount of pip using test e but after switching brands because i thought it might be an adverse reaction to the oil there wasn't much difference. my bro and i run the same gear from the same source and he's never had a problem. both of us agree though that warming it up makes a difference. he likes it cuz its easier to draw and i do the same because it lessens the pip. everyone reacts differently i guess.

Use a hotplate and stir rod brotha. I screwed up so much shit on the dam oven!!!!