Steroids Source Talk | Anabolic Steroid Forum - View Single Post - IGF-1 LR3 Overview

admin · #2 (**permalink**) 12-09-2015, 08:13 PM

Reconstituting IGF-1lr3
Reconstitution is simply the addition of the 0.6% AA to your lyophilized IGF-1.
Assumption: 1mg/mL IGF-1/AA (1mg IGF-1 will be combined with 1mL AA; 1mg IGF-1 is the same as 1,000mcg)

1. Swab the top of your IGF-1 vial with a sterile alcohol prep pad
2. Swab the top of your 0.6% AA vial with a sterile alcohol prep pad
3. Using either multiple insulin syringe volumes (example: 2 x 0.5cc) or a single large syringe, obtain 1.0mL of 0.6% AA.
4. In the IGF-1 vial, insert a sterile ~20 ga. needle to act as a vent
5. Inject the 1.0mL of AA very slowly and dribble it down the side of the vial.
a. Be very careful with this peptide as it is very delicate!
6. Remove the needle & syringe and discard
7. Gently swirl the vial or roll between your hands.
a. Again, be very gentle here
8. You now have 1mg/mL of IGF-1
a. This is the same as: 1,000mcg/mL

Notes:
1. If you added 2mL of AA, it would be a 0.5mg/mL
2. I have an Excel calculator that will help you with these calculation.

Injecting IGF-1lr3
If this is your first time with injections, don***8217;t worry. You will be using a very fine gauge insulin syringe which means you will most likely have nearly effortless injections. These things are so tiny and sharp you may not even feel it penetrating. If you use sterile procedure, aspirate prior to injection, and have diluted your IGF-1/AA solution with enough bacteriostatic water (BW), you should have no issues with your injections and very minimal post-injection discomfort (if any at all!).

I cannot stress enough the importance on two topics: A) sterility, and B) pre-injection aspiration. Always swab the injection site(s) with a sterile isopropyl alcohol (IPA) pad and aspirate prior to injecting the IGF-1. No questions asked!

You will most likely intramuscular (IM) injections, but subcutaneous (sub-q) injections are also followed by some, but current theory is that IM will yield a localized effect. By ***8220;localized effect***8221;, I am referring to the effect IGF-1 will have at the injection site. So if you inject IM into biceps, it is thought that your bicep muscles will get more of a dose of IGF-1 than other parts of your body (some which you don***8217;t want to be effected, such as the intestines). Both types of injections will have systemic effects (affecting the body as a whole). Long R3 IGF-1 has an estimated half-life of 20-30hrs (taken from IGTROPIN data).

This guide assumes you will be doing bilateral IM injections. More below.

Bilateral injections are injections that are evenly divided between two muscles. If you are injecting 40mcg (micrograms) bilaterally, you will be injecting 20mcg into the right bicep and 20mcg into the left bicep.

Current theorized best practice is to you inject your peptide post workout (PWO). You have a small window of optimal opportunity. Ideally, you would inject immediately PWO, but some do not like the idea of injecting in a public location, such as the gym. Your next best option is to make your way home ASAP and have your needles loaded and ready (with your alcohol swabs sitting near by).